Print Settings Generator
Starting-point settings for your material, printer, and print type
Generated settings
Select options and click Generate settings to see recommendations.
Popular spools for these profiles
Settings only get you so far; these are popular spools that suit these starting values.
eSUN PLA+
A common budget PLA: consistent diameter and a huge color range; a good match for the generator's PLA starting values.
SUNLU PETG
Cheap, widely used PETG for functional parts; start from the profile's stock temperatures.
Overture TPU 95A
Flexible 95A that stays predictable at the low speeds our TPU profile suggests.
PRILINE Carbon Fiber PC
Carbon-fiber PC for stiff, matte functional parts; use the PC profile. Requires a hardened steel nozzle.
SUNLU FilaDryer S2
Wet filament invalidates any settings; dry PETG and TPU before you start tuning. SUNLU rates the S2 for 70°C, so nylon needs long runs.
Affiliate links. We may earn a small commission at no extra cost to you.
Temperature reference
| Material | Nozzle range | Bed (PEI textured) | Notes |
|---|---|---|---|
| PLA | 190–240°C | 35–45°C (old Cool Plate), 45–65°C (other plates) | Most forgiving material |
| PETG | 240–270°C | 60–80°C | Prone to stringing; not recommended on the old Cool Plate (the Cool Plate SuperTack takes PETG). PETG HF: 230–260°C |
| ABS | 240–280°C | 90–100°C | Requires enclosure; ventilate fumes |
| ASA | 240–280°C | 90–100°C | Like ABS with better UV resistance |
| TPU | 200–250°C | 35–45°C | Print slowly; retraction at the profile value; never on the Cool Plate SuperTack |
| Nylon (PA) | 240–280°C | 100–120°C | Must be dry; hygroscopic |
| PC | 260–290°C | 100–120°C | Enclosed printer only; Bambu suggests a 45–60°C chamber; dry first (80°C, 8 h) |
Nozzle ranges: Bambu Lab filament material table (listed with a ±10°C tolerance); bed ranges from the same table's build plate settings. Plain nylon is not in its nozzle list; the PA nozzle range and the generator's 100°C PA bed default are from Bambu Studio's Generic PA profile. The TPU speed cap follows the Generic TPU profile (3.2 mm³/s); TPU retraction advice: Bambu's stringing guide; TPU container, AMS HT TPU outlet and TPU 85A limits: Bambu TPU printing guide. Plates: Bambu Cool Plate SuperTack (PLA and PETG, TPU damages it); the old Cool Plate is discontinued.
- Page
- Status
- Not affiliated with Bambu Lab